cecotec CONGA 1790 ULTRA Manual De Instrucciones página 42

ENGLISH
Press the dust tank's release button.
Fig. 39
Open the dust tank and empty it.
Fig. 40
Cleaning of the robot's filter
Remove the filter.
Carefully shake off all dust from the filter.
Fig. 41
Cleaning of the free-fall sensors
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
right side of the robot's bottom part.
Warning: Do not spray cleaning products directly on the sensor.
Fig. 42
Cleaning of the main brush
Slightly press the main brush frame's tabs in order to open the main brush storage gap and to
remove it.
Fig. 43
Remove any hair, fluffs or dust collected in the brush and around the axes.
Fig. 44
Clear and clean the robot's suction channel.
Fig. 45
Reinstall the main brush and its frame.
Fig. 46
High-efficiency filter
The high-efficiency filter is designed with fibres that help trapping dust particles, dust mites,
pollen... It is very important to clean periodically the filter, to avoid these particles from building
up in the filter, causing efficiency loss. It is convenient to carry out this maintenance once a
week.
It is suggested to replace the filter by a new one after a maximum of 160 hours of use.
Recommendations: Dirt can be removed with a small brush or by shaking it carefully against a
hard surface for dust to fall off. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter
The filtering system is featured with a mesh primary filter and a sponge filter. It is suggested
to replace them either after a maximum of 160 hours of use or when they are worn out due to
operation.
Recommendations: Dirt can be removed with a small brush or by shaking it carefully against
42