S&P TOWER-2000 PTC Manual De Instrucciones página 8

• Do not clean the product while it is working and do not immerse it in water.
• Do not handle the heater with wet hands.
• Do not coil the power cable around or on top of the product while it is working.
• If the cable gets damaged it must be replaced by S&P – take the equipment to our offi cial S&P
because the work must be done by specialist personnel to avoid any risk of damage.
• The heater must always work vertically, with the controls at the top and the base located on a
stable surface.
• Only for internal use.
2. THE PRODUCT
Description of the product (Figure 1):
A LCD screen
B Control panel
C Ceramic heater element (PTC)
D Base oscillation
E Safety tilt switch
F Feet main switch
G Remote control
H Receiver remote control
- Transport handle
- Input air fi lter
3. USE AND OPERATION
• Before connecting the product to the power, make sure that it is located on a stable fl oor and has a fi rm vertical position.
Remember that as a safety feature, the product incorporates a safety tilt switch under the base (Fig.1 D-E).
• You can control the ceramic heater through the control panel (Fig.1B) or with the remote control (Fig.1G).
• CONTROLS
POWER
The product has two on and off switches. One is generally located at the base of the appliance (Fig.1F) and the other in
the control panel / remote control. To operate the device, both must be on.
IMPORTANT: To preserve the life of the heating element (Fig. 1C), the appliance incorporates an automatic cooling sys-
tem, so that when you disconnect the appliance using the POWER button of the control panel/ remote control, the fan
continues to run for 30 seconds.
Do not unplug the heater by directly acting on the main foot switch (Fig.1 F) or pulling the power cable.
MODE
You can select up to 3 different operating modes:
– FAN mode: Fan cold air.
– LOW-HIGH Mode: Manual selection of the heater power.
Low
High
The heater works to continuously selected power, regardles of the room temperature.
– AUTO Mode: The power heater is self-adjusted automatically depending on the room temperature.
When you select this operating mode, using the +/- keys can be programmed (SET) the desired
temperature in the room (+15 ~ +35ºC).
When the room temperature approaches the comfort temperature programmed by the user, the
heater will automatically regulate the power while constantly maintaining temperature in the
room. Remember that the comfort temperature is between 21-22ºC.
8
: 1.000 W
: 2.000 W