CMT 656 Manual De Instrucciones página 8

EN
MAKING DOWEL JOINTS
Drilling holes on the surface
Tighten the metal stop ring in the hole at the edge of the template. Place the template on the work
piece so that the end stop ring touches the front edge of the work piece and the surface of the tem-
plate A points towards the opposite side of the work piece (Fig. 6).
Make certain the stop ring touches the front edge of the board and the inner parts of the template
lies directly on the work piece. Now fix the template with the clamps, which are tightened firmly by
hand – forcing is unnecessary. Set the drilling depth on the chuck adaptor. Put the chuck adaptor
with its appropriate drill bit in the holes and start drilling the dowel holes (Fig. 6). Drill deep holes
gradually so that chips can be removed. Make certain the drill rotates in the correct direction – these
are right-hand bits.
CMT400-1
Fig. 6
8
www.cmtorangetools.com