Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
MAKING DOWEL JOINTS
Making corner joints
The various work pieces for constructing a cupboard are shown in (Fig. 4).
- Before drilling, always check that the inner part of the system is perfectly up against the work piece.
- Always match the system with the work piece, starting from the front edge; when drilling in the
edge, the clamps must be pointed towards the opposite side, never in any other direction! This
will create a 0.8mm facet.
- Check drilling depth before drilling.
- If the drilled hole is not clean, sharpen the drill bit.
Fig. 4
6
A
B
0,8mm
40mm
www.cmtorangetools.com
Tabla de contenido
