CMT 656 Manual De Instrucciones página 4

EN
DESCRIPTION AND USE OF CMT400-1 AND CMT400-2
Description of CMT400-1 and CMT400-2 chuck adaptor
The chuck adaptor consists in a duralumin centring bush and a 9mm diameter chuck shaft with a
Ø8mm hole for fitting the drill bits. The shank is fitted in the centring bush, where the bearings provide
maximum precision. For holding in place, there is a spring and a stop ring locked with a screw. Drilling
depth is set by the stop ring; for drilling depth range see (Fig. 2 and 8).
The CMT400-1 drilling bush is equipped with a gauge with a 5mm scale (Fig. 2).
CMT400-1
Fig. 2
CMT400-2
Fig. 8
CMT400-1 and CMT400-2 - contents
1 pc Duralumin chuck adaptor (complete)
1 pc Centering pin Ø5mm (CMT400-2 adaptor only)
1 pc Centering pin Ø7mm (CMT400-2 adaptor only)
1 pc 2mm hex key
4
5-30mm
37-45mm
5mm
www.cmtorangetools.com