3- Pressure Switch Regulation - Bomba Elias GPG Serie Manual De Instrucciones

GPG 70, GPG-D 70, GPG 200 M, GPG-D 200 M, GPG 200 T, GPG-D 200
T, GPG 500 T, GPG-D 500 T, GPG 1000, GPG-D 1000, GPG 1600, GPG-D
Models
1600, GPG 2500, GPG-D 2500, GPG 3500, GPG-D 3500, GPG 5000, GPG-
D 5000
1. Firstly, when the set has no pressure, the pressure switch will keep the pump/s
2. In these conditions, the pump will only work if the push button on the electrical
3. Open some point of the discharge, where the air, closed in the pipes, can be
Steps to
follow 4. Operate the pressure switch lever and keep it (START position) until the fuel
5. Close the opening of the valve at the output of the set to fill the accumulator
6. At this moment, the push button can stop being pressed because the set will

3- Pressure switch regulation

Models GPG 20, GPG-D 20, GPG 35, GPG-D 35, GPG 85, GPG-D 85, GPG 235
1. Regulate the pressure as needed but keep in mind not to exceed the pressure
2. The pressure on the accumulator must be 200 grams below the start-up
3. Tightening or loosening the knob (A, in the following figure) we obtain the
4. The other knob (B, in the following figure) allows us to adjust the differential
Directions
for use
Manual de instrucciones/Manual/Manuel d'instructions "GPG/GPG-D"
and the indicator light on.
panel remains pressed.
purged.
goes out through the opening previously made.
and increase the pressure until the safety pilot turns off.
be able to work automatically.
values previously indicated.
pressure.
starting pressure point.
pressure and, consequently, to choose the pressure booster set stopping
pressure.
"GPG/GPG-D"
P á g i n a
19 | 36