Installation Instructions; Electrical Connections - Hoshizaki FM-120EE Manual De Instrucciones

IMPORTANT
. This booklet is an integral and essential
part of the product and should be kept
and preserved by the user. Please read
carefully the guidelines and warnings
contained herein as they are intended
t o p r o v i d e t h e u s e r w i t h e s s e n t i a l
information for the continued safe use and
maintenance of the product. In addition,
it provides GUIDANCE ONLY to the user
on the correct services and site location of
the icemaker. Please preserve this booklet
for any further consultation that may be
necessary.
2. This is a commercial icemaker, and should
be destined only to be used for the purpose
for which it has been expressly designed.
A n y o t h e r u s e s h o u l d b e c o n s i d e r e d
improper and therefore dangerous. The
manufacturer will not be held liable or
responsible for any damage caused by
improper, incorrect and unreasonable use.
I. INSTALLATION INSTRUCTIONS
WARNING
The in s t a l la t i on m us t b e c a r r ie d o ut
by qualified personnel, in accordance with current regulations, according to the
manufacturer's instructions.
1. LOCATION
IMPORTANT
. T h i s i c e m a k e r i s n o t i n t e n d e d f o r
outdoor use. Normal operating ambient
temperature should be within 5°C to 40°
C. Normal operating water temperature
should be within 5°C to 35°C. Operation of
the icemaker, for extended periods, outside
of these normal temperature ranges may
affect production capacity.
2. The icemaker should not be located next to
ovens, grills or other high heat producing
equipment.
3. The location should provide a firm and level
foundation for the equipment.
4. Allow 5 cm clearance at rear, sides and
top for proper air circulation and ease of
maintenance and/or service should they be
required.
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. D o n o t p l a c e a n y t h i n g o n t o p o f t h e
icemaker or in front of the Louver.
7. This icemaker will not work at subfreezing
temperatures. To prevent damage to the
water supply line, drain the icemaker when
air temperature is below zero (see "II. 2.
PREPARING THE ICEMAKER FOR LONG
STORAGE").
8. The noise from this icemaker is 55 dB or
less.

2. ELECTRICAL CONNECTIONS

WARNING
THIS APPLIANCE MUST BE EARTHED
This icemaker requires an earth that meets
t h e n a t i o n a l a n d l o c a l e l e c t r i c a l c o d e
requirements. To prevent possible severe
electrical shock to individuals or extensive
damage to equipment, install a proper earth
wire to the icemaker. Remove the plug from
the mains socket before any maintenance,
repairs or cleaning is undertaken.
* This icemaker must have a separate power
supply or receptacle of 220 - 240V.
* The main control box circuit breaker is rated at
6A and should only be replaced by a qualified
service engineer.
* Usually an electrical permit and services of a
licensed electrician are required.
* If the supply cord and the plug should need to be
replaced, it should only be done by a qualified
service engineer.
For the U.K. and the Republic of Ireland only
* The wires in the mains lead are coloured in
accordance with the following code:
Green & Yellow = Earth
Blue = Neutral
Brown = Live
As the colours of the wire in the mains lead
of this appliance may not correspond with the

ENGLISH