nilco Combi Serie Instrucciones De Uso página 41

Fault
Appliance does not work.
Appliance suddenly stops
vacuuming.
Vacuum cleaning is
unsatisfactory.
Brush does not work.
Appliance runs unusually loud.
Troubleshooting...
Possible cause
Plug is not inserted or the
appliance is not switched on.
Power outlet does not carry any
power.
Power cord is damaged.
Overheat protection has tripped
(possibly due to clogged suction
channels, dirty filters, etc.)
Dust bag is full.
Filter is dirty or clogged.
Nozzle, suction tube or suction
hose are clogged up.
Suction regulator is open.
The power setting does not suit
the flooring.
The attached nozzle does not fit
the flooring.
The "carpet/hard floor" switch is in
the wrong position for the
particular type of floor.
Connecting cable [D] is loose
or not connected.
Suction tube is loose.
Sucked-in particles have become
jammed.
Solution
Insert de plug into a mains socket and
switch on the appliance.
Test the appliance at another socket
which you are sure carries current.
Have the power cord replaced by an
authorised Fakir service centre.
Switch off and unplug the appliance.
Eliminate the cause of overheating
(e.g. clogged suction channels, dirty
filters, etc.). Wait 45 minutes and let the
appliance cool down. Then switch on
the appliance again.
Change dust bag.
Clean or change the corresponding
filter.
Eliminate clogging. If necessary, use a
wooden stick (e.g. a broomstick) to do
this.
Close suction regulator.
Set the power to the setting suggested
for the flooring.
Attach the correct nozzle.
Set the "carpet/hard floor" switch to the
correct position for the type of floor.
Connect cable [D] correctly
– see page 32.
Insert suction tube correctly,
see page 33.
Remove particles. If necessary, use a
long wooden stick (e.g. a broomstick).
GB
41