After Use; Motor Protection Filter; (Micro) Exhaust Filter; Hepa-Filter - Model 1107 - nilco Combi Serie Instrucciones De Uso

Cleaning and replacing
brush roller and drive
belt
N
N

After use

Motor protection filter: 17-30, 17-36, 17-46

After replacing the dust bag 5 times or if very dirty, the
motor protection filter must be cleaned or washed out,
then dried completely before being re-inserted.

(Micro) exhaust filter

After replacing the dust bag 5 times or if very dirty, the fil-
ter must be replaced.
Remove the filter cassette from the guiding device by
pulling it upwards. Replace the filter, close the cassette
and insert into the guide as far as it will go.
Changing the HEPA filter: Premium 1107
Change the HEPA filter after approx. 6 months or in case
it is extremely dirty.
WARNING!
Switch off and unplug the appliance before beginning
cleaning or maintenance. If the mains plug is plugged
in, the appliance could accidentally be switched on, re-
sulting in injuries.
To keep the electronic suction brush working efficiently,
you should remove hair, fibres and threads, etc. at
regular intervals from the brush roller and, if necessary,
from the drive belt.
● To remove the bottom plate, turn the levers [N] until
they are horizontal.
On Model 17-46, also remove the screw [O].
● Hold the brush roller firmly on both ends, lift together
with the bearings and withdraw it laterally from the dri-
ve belt.
O
● Remove hair, fibres, threads, etc. which have wound
around the brush roller, using a knife or scissors.
Thoroughly clean the brushes of the roller and the dri-
ve belt (brush off and or vacuum clean).
GB
37