The Inner Components; The Air Intake; The Retention System - AGV Orbyt Manual Del Usuario

English
Attention! Make sure the sun visor is firmly fastened to the engaging mechanisms. If, while
moving it, you can hear the sun visor rubbing against the polystyrene shell, get it out and back in
again, making sure that the slots on the two ends are engaged by the moving mechanisms for
their whole length.
CLEANING
As to cleaning the sun visor, please refer to the paragraph about cleaning the visor.

THE INNER COMPONENTS

Reference figures on page 63
The inside of the Orbyt helmet consists of two cheek pads and a crown pad, both
removable and washable. On the back, there is also a neck roll that cannot be
removed.
We recommend that installation and removal are carried out sitting down, placing the helmet on
your legs.
THE CHEEK PADS: REMOVAL AND INSTALLATION
To remove a cheek pad, hold it in the front of the helmet and pull towards the inside, unfastening
the 4 automatic buttons (fig. 18).
To refit a cheek pad, place it on its Velcro support housing. Then secure it, fastening the 4 auto-
matic buttons.
THE CROWN PAD: REMOVAL AND INSTALLATION
To remove the crown pad, unfasten the 2 front automatic buttons and the single one on the back
(fig. 19).
To install the crown pad, place it inside the helmet. Fasten the 2 front automatic buttons and
the single one on the back.
Attention! Remove the crown pad, making sure you have unfastened all the automatic buttons,
to avoid damaging the buttons themselves and/or unpick the fabric parts.
WASHING THE INNER COMPONENTS
After removing them from the helmet, the inner components must be hand washed by immers-
ing them in warm water with laundry detergent. Rinse with running water. Do not squeeze them
and let them dry at ambient temperature away from direct sun.
16

THE AIR INTAKE

Reference figures on page 65
An air vent is provided on the top of the outer shell of the Orbyt helmet, guarantee-
ing efficient ventilation. The vent cannot be removed.
OPENING AND CLOSING
To open the air vent, move the cursor backwards (fig. 20). To close it, move it forward (fig. 21).

THE RETENTION SYSTEM

Reference figures on page 66
The retention system of the Orbyt helmet is the buckle-type with micrometric fas-
tening. Before using the helmet, the length of the strap must be set, to get an ade-
quate fit when the chin guard is fastened.
Attention! To ensure the helmet safe fit, make sure you have chosen the right size: check
the paragraph "Choosing the right helmet" in the Instruction and safety warnings booklet.
ADJUSTING THE STRAP
We recommend you adjust the strap sitting down, placing the helmet upside down on your legs.
Act on the loop, increasing or diminishing the length of the strap through it (fig. 22).
MICROMETRIC ADJUSTMENT OPENING AND CLOSING
To close the micrometric adjustment buckle, insert the toothed tab into the tightening mechanism
(fig. 23) and push until you feel the chin guard press against your jaw (fig. 24). Make sure that
the helmet sits tight on your head.
To unfasten the chin guard and open the micrometric adjustment buckle, lift the red lever with
the help of the fabric tape (fig. 25). Then, take the toothed tab out of the micrometric adjustment
buckle.
Attention! Even if the micrometric adjustment allows identifying a comfortable position so that
the chin guard is not too tight, it is however advisable to insert the tab into the tightening mecha-
nism as far as possible.
English
17