Idiomas disponibles
Idiomas disponibles
POWERTEX Chain Block PCB-S1 0.25 – 20 tonnes
Instruction for use (GB) (Original instructions)
Read through these user instructions carefully before using the chain block. Improper operation may lead to hazardous situations!
General safety provisions
•
Check the function of the chain block before use. See "Daily checks" on page 3.
•
Full function of the brake system can only be secured at a minimum load of 30 kg for capacities (WLL) up to 1 ton,
and for capacities (WLL) above 1 ton, the minimum load to be greater than 3% of the rated capacity (WLL).
•
Do not exceed the maximum load.
•
Handle the chain block with care. Do not throw the block about or let it fall to the ground.
•
Do not use the chain block for welding work where it is exposed to welding spatter or current.
•
The chain block must not be used for lifting persons.
Technical data
0,25, 0,5, 1, 2, 3t
Model
WLL ton
Standard lifting height *) m
Number of block falls
Pull on hand chain daN (kp)
Load chain
Dimension A mm
Dimension B mm
Dimension C mm
Dimension Ø mm
Dimension E mm
Dimension H min mm
Weight for standard lift height kg
*) Length of hand chain due to lifting height.
Safety factor: 4:1.
Static test coefficient: WLL x 1,5.
Generally according to EN 13157.
Function
The load hook is raised or lowered by pulling on the hand chain. The load will remain where it is even when the hand chain is released because
of the effective reaction brake.
Suspension of chain block
Suspend the block from an eye, shackle, girder trolley etc. with sufficient load capacity. With the chain tightened, both hooks must be vertically
aligned.
NB!
No bending stresses may be applied to block, hooks or load chain.
Raising/lowering
Only use straps and slings of sufficient load capacity. Check that the load is not anchored to the floor/ground or is otherwise fixed before making
the lift. Ensure that the load chain hangs vertically and has no kinks. The hand chain must also be in good condition and easily accessible. The
load is raised or lowered by pulling the hand chain in either direction.
Warning:
•
Only hand power from a single person is permitted on the hand chain. If the chain feels too heavy, use a bigger chain block or reduce the load.
•
Make sure no-one stands beneath a hanging load.
•
Do not step onto a hanging load.
•
Do not raise or lower so far that the load hook hits the block housing.
•
The chain block must not be used for pulling loads.
•
The block must not be subjected to dynamic stresses, for example where a load connected to the block is launched from a height.
•
Do not leave a block with a suspended load unattended.
5t
PCB-S1
PCB-S1
PCB-S1
0,25
0,5
3
3
1
1
19
21
5x15
4x12
6,3x19
106
128
142
75
68
150
108
130
18
20
20
22
280
330
360
6,4
8,9
10t
PCB-S1
PCB-S1
1
2
3
3
3
3
1
1
1
29
36
41
8x24
10x30
175
195
76
95
88
185
226
25
33
36
35
37
26
470
560
19,5
12
29,4
2
PCB-S1
PCB-S1
PCB-S1
5
10
3
3
2
3
40
46
2x40
9x27
9x27
10x30
195
183
183
95
90
255
355
577
43
44
110
47
44
690
810
1.060
185
36,6
64,1
20
3
8
90
70
