Selecting The Operating Mode - WIKA GFU08 Manual De Instrucciones

7. Display unit
7.9.1 Restoring the printing and display functions
During the use of the display unit, it is possible that the error "no.0 . un5" is shown on
the display and a signal tone sounds. This means that the printing or the function to be
carried out must be re-enabled (in order to prevent unwanted applications).This function
is very useful in order to, for example, prevent a duplicate data output on the printer
or PC, or even a double summation.It is possible to define this restoration in different
ways in the SETUP area: "Returning the net weight over 0", "Instability of the weight" or
"always".
7.9.2 Display of the metric data
The display unit is fitted with the function "inFO". Through this it is possible to display the
metric data of the scales:
▶
hold the C button down until the word "inFO" is shown on the display or
▶
press the MODE + C buttons

7.10 Selecting the operating mode

In addition to the standard weighing mode, tare deduction and the output of data, the
display unit can be switched to the following operating modes:
Changing over weight unit
■
Switching between gross/net
■
Input/output ("inout")
■
7.10.1 Changing over the weight unit
By pressing the MODE button, it switches between kg and lb and vice versa.
▶
The calculation is carried out for the weight unit that is set during the
calibration.
▶
After changing the weight units over, the display unit must be
recalibrated.
7.10.2 Switching between GROSS/NET
If a tare has been entered, by pressing the MODE button, the gross weight is shown
on the display for 3 seconds.During the display of the gross weight, no printing can be
made.
WIKA operating instructions SF gas filling cart, model GFU08
6
EN
31