Bosch GAM 220 MF Instrucciones De Funcionamiento Y Seguridad página 11

"2. CNR": Storing the Corner Angle
CNR
To measure the corner angle, place the fold-out and base
legs flat against the walls and read the measured corner
angle or set a known corner angle on the anglefinder.
"3.MTR": Calculating the Miter Angle
MTR
Press button 15 again. "MTR" and the calculated miter
angle for the chop and miter saw are indicated on the
display.
"4. BVL": Calculating the Bevel Angle
BVL
Press button 15 again. "BVL" and the calculated bevel an-
gle for the chop and miter saw is indicated on the display.
If required, the miter and bevel angle can be recalled
again, but only as long as button 12 for changing the op-
erating mode has not been pressed. Press button 15 to
recall the angles. "MTR" and the calculated miter angle
are indicated in the display; after pressing the button 15
once more, "BVL" and the bevel angle will be indicated.
Press button 14 to return from the "Compound Miter"
operating mode to the "Angle Measurement" operating
mode.
Note: The calculated miter angle "MTR" can only be tak-
en over for chop and miter saws, for which the setting for
vertical cuts is 0°. When the setting for vertical cuts is
90°, the angle for the saw must be calculated as follows:
90° – indicated "MTR" angle = angle to be set on the saw.
11
2610035049 GAM220MF 05-19.indd 11 5/22/19 10:08 AM