Useful Suggestions - TRAPP ES-500 Manual De Instrucciones

www.trapp.com.br
Throghout the use of the shredder situations and or problems may occur, for which we present some
suggestions:
Trouble
Shredder jamming
Low production
Irregular cut
Trouble starting motor

Useful Suggestions

Probable cause
Excessive intake/feeding.
Due to this the motor can not
maintain necessary rotation,
and the material accumulates
inside the shredder. Use under
this condition may cause motor
to overload.
Insufficient feeding of shredder
1 - Cutting blades need
sharpening
2 - Counter cutting blade worn
or not regulated properly
3 - Insufficient feeding of
cylinder feeder
1 - Excessive intake of product
in shredder.
2 - Electrical shortage.
Solution
Turn off shredder and wait for motor to come to a full
stop. Open the lid, remove excess material, close lid,
turn on shredder, wait for motor to reach maximum
rotation and restart work. Control intake/feeding
according to motor's capacity.
Maintain a continuous feeding flow, yet not over-
feeding which may cause the shredder to jam.
1 - Sharpen cutting blades as indicated in Maintenance
(page 49).
2 - Proceed as indicated on page 50 Maintenance of
Counter Cutting Blade.
3 - Increase the tension of cylinder spring (see page 47).
Substitute upper cylinder if worn.
1 - Once work is finished, always leave shredder
working for a few extract minutes to allow all
material to exit.
2 - Check condition of electrical power source.
51