TRAPP ES-500 Manual De Instrucciones página 46

Ocultar thumbs Ver también para ES-500:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Feeding of the animal ration shredder shall be
continuous and adequate to the capacity of the green
funnel, considering the machine/motor assembly.
Note:
Feed the machine in bundles. Always
place a new bundle over the final part
of the product going into the machine,
providing continuous feeding and
uniform cutting.
Foliage cutting length -5 mm or 10 mm
(ES-500/ES-600) and 4 mm, 6 mm, 8 mm or 12 mm
(ES-550/ES-650), - is determined by the position of the
belt in the pulley.
To replace the belt, follow the items described below
and shown in the pictures.
With the machine off:
Remove the 2 screws (A) and the belt protection


(B).
Remove the 4 screws (C) that secure the


transmission box.
Loosen the stretching screw (D).


Change the belt to another channel, observing the


positions indicated in the figure.
Stretch the belt with the stretching screw (D).


Retighten the 4 screws (C) that secure the


transmission box.
Replace the belt protection (B).


C
D
46
Feeding
Length of Cutting
B
A
!
Attention!
Before switching off the animal ration
shredder, allow all products to exit the
machine so that it is completely empty.
Only then, switch it off.
Adjusting length of cut
Box pulley
ES-500 and ES-600
5 mm
10 mm
ES-550 and ES-650
4 mm
6 mm
8 mm
12 mm
www.trapp.com.br
Cutting disk pulley
Tabla de contenido
loading

Este manual también es adecuado para:

Es-550Es-600Es-650

Tabla de contenido