TRAPP ES-500 Manual De Instrucciones página 44

Coupling to the Tractor and Placing the Cardan
Animal ration shredders with
accessory for tractors
Couple to the three points of the tractor hydraulic
 
system (first the two lower arms and then the
upper arm).
Disconnect the two parts of the cardan (male/
 
female).
Couple the cardan to the tractor power outlet.
 
Place the two parts of the cardan parallel to each
 
other and mark the cutting area, allowing 2.5 cm
on each end.
Cut the excess on the male and female ends.
 
Connect the parts of the cardan and couple it to
 
the tractor.
Note:
The pieces cut from the solid and tubular
 
parts of the cardan shall have the same
length.
Allow at least 2.5 cm on each end of the
 
cardan.
Instructions on how to cut, lubricate,
 
maintain and place the cardan
protection chain are described on the
leaflet supplied by the manufacturer
which is attached to the cardan.
44
2,5 cm
gap
Keep terminals aligned
www.trapp.com.br