Idiomas disponibles
Idiomas disponibles
Product Information
– Always keep these instructions together with the product even when given to other persons.
– Read the safety data sheet before use.
– Check expiration date (month/year) imprint on the label. Do not use expired product.
– Cartridge temperature during usage: -23 °C to 32 °C / -10 °F to 90 °F.
– Base material temperature at time of installation: between -23 °C to 32 °C / -10 °F to 90 °F.
– Conditions for transport and storage: Keep in a cool, dry and dark place between 5 °C and 25 °C
/ 41 °F and 77 °F.
– For any application not covered by this document / beyond values specified, please contact Hilti.
– Partly used cartridges have to be used within 4 weeks. Leave the mixer attached and store under
the recommended storage conditions. If reused, attach a new mixer and discard the initial quantity of
anchor adhesive, as described at paragraph 8.
Installation instructions
Follow the illustrations on page 2-3 for the sequence of operations and refer to tables on page 4-6 for
setting details.
Drill hole with a hammer-drill set in rotation hammer mode using appropriately sized
carbide drill bit.
– Clean hole: Just before setting an anchor/rebar, the borehole must be free of dust, debris,
water, ice/frost and other contaminants.
Method 1: Manual Cleaning
• Blow - 4 strokes with Hilti blow-out pump with the nozzle extended to the back of the hole
until return air stream is free of noticeable dust.
• Brush - 4 times with the specified HIT-RB brush size (brush Ø ≥ borehole Ø) by inserting
the round steel brush to the back of the hole with a twisting motion and removing it.
• Blow - 4 strokes with Hilti blow-out pump with the nozzle extended to the back of the hole
until return air stream is free of noticeable dust.
Method 2: Compressed air cleaning
• Blow from the back of the borehole with oil-free compressed air (min. 6 bar at 6 m3/h)
fully retracting the air extension 2 times until return air stream is free of noticeable dust.
• Brush 2 times with the specified HIT-RB brush size (brush Ø≥ bore hole Ø) by inserting
the round steel brush to the back of the borehole in a twisting motion and removing it. The
brush should resist insertion into the borehole - if not, the brush is too small and must be
replaced with a brush of appropriate brush diameter.
• Blow again with compressed air 2 times until return air stream is free of noticeable dust.
If required use extensions for air nozzle and brushes to reach back of deep hole.
Unscrew the cartridge's cap.
Screw on the Hilti HIT-M2 Mixing nozzle tightly. Do not modify the mixer in any way.
Use only the type of mixer supplied with the adhesive.
Insert the cartridge into the Hilti HIT-MD 1000 dispenser.
Printed: 19.08.2016 | Doc-Nr: PUB / 5098739 / 000 / 03
Hilti HIT-ICE
en
9
