Dräger RH 600 Instrucciones De Uso página 52

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

What's what
Control panel
14
13
12
11
10
1
Power switch
2
Lamp switch
3
Push-button for »Man« (manual) mode;
when activated, the green LED is lit.
4
Push-button for acknowledging the intermittent
alarm tone that is sounded every 15 minutes at
heater level 5 and above to remind the user to
measure the core temperature.
The yellow LED goes out after the alarm is
acknowledged.
5
Green bar-segment display for the heater output
level; one segment corresponds to a heater level
of 10% max. heater power;
To the left of the bar display:
Key for reducing the heater level.
To the right of the bar display:
Key for increasing the heater level.
6
Push-button for »Auto« (automatic) mode;
the green LED comes on when the button is
pressed = skin temperature control activated.
7
Red LED "Sensor":
comes on during skin temperature control if the
skin temperature sensor is removed or defective.
8
Follow the Instructions for Use of the skin
[
temperature control.
Red LED ±0,5 °C;
9
flashes when the measured skin temperature
deviates by more than ±0.5 °C from the set value.
52
Start
°C
°C
Check
36°C
Auto
±0,1
±0,5°C
Sensor
[
9
8
7
6
15
16
min
sec
Stop
Reset
Inop.
Reset
Man
15 min
D
5
4
3
10 Connection for skin temperature sensor
11 Push-button for muting the intermittent alarm tone for
10 minutes;
the yellow LED comes on while the intermittent tone
is muted.
12 Push-button for simulating the temperature
36 ±0.1 °C (function check).
13 Display for the set value of the skin temperature.
To the left of setpoint display:
Key for reducing the skin temperature setting.
To the right of setpoint display:
Key for increasing the skin temperature setting.
14 Display for the actual measured skin temperature.
15 Timer display.
To the left of the display:
Start key.
To the right of the display:
Stop key (1x)
Reset key (2x)
O O O O
16 Yellow LED
;
lights up/flashes according to heater phases.
N N N N
17 Red LED
;
lights up in the event of a power failure.
18 Red LED Inop;
lights up in the event of a malfunction.
17
18
2
1
Tabla de contenido
loading

Tabla de contenido