Tabla de contenido
Wipe the remnants of the abraded skin from the feet.
Dry the feet thoroughly.
Attention: Do not apply to one area of the foot for longer than 3-4 seconds. In the case of irritation or redness
of the skin, stop the procedure.
Final treatment of the feet
To soften the sanded skin, use the head with the sponge. Apply cream to the foot or the head of the brush and
roll the brush across the feet until the cream is absorbed.
CLEANING AND MAINTENANCE
The massage device is a device for personal care, not a wash bath. Before the massage, wash your legs in clean
water. The deposited particles block the air nozzles and limit the bubble effect.
Unplug the device and let it cool down before cleaning. After use, rinse the massage device with clean water.
Never immerse the entire device in water!
Use a wet cloth for cleaning. Do not use aggressive chemical substances or abrasive cleaners. To prevent the
build up of bacteria, regularly clean the device and the individual components with mild disinfectant.
The massage device can only be stored after it has been completely turned off by main switch disconnected
from the outlet, is completely empty and has dried and cooled down. Before storing, wrap the power cord
around the winding holder on the lower side of the device. Never hinge the device at the cable. Never connect
the device into the electricity outlet if the cable is partially wound around the device.
Wipe the body of the cosmetic device with a soft, wet cloth. Clean the replacement heads with running water
and leave to dry.
TECHNICAL DATA
Nominal voltage: 220-240 V ~ 50/60 Hz
Nominal input power: 90 W
Supply of brush: 2× AA batteries
DC 3 V, 3 W (not included in
the package)
WARRANTY: The following situations void the warranty:
Incorrect or inappropriate handling of the device, failure to observe safety measures applicable to the device,
the use of force, alterations or repairs made by a party other than an authorized service centre.
Components subject to normal wear and tear are not covered under the warranty.
USE AND DISPOSAL OF WASTE
Wrapping paper and corrugated paperboard – deliver to scrapyard. Packing foil, PE bags, plastic elements – throw into plastic
recycling containers.
DISPOSAL OF PRODUCTS AT THE END OF LIFETIME
Disposal of electric and electronic equipment (valid in EU member countries and other European
countries with an implemented recycling system)
The represented symbol on the product or package means the product shall not be treated as domestic waste.
Hand over the product to the specified location for recycling electric and electronic equipment. Prevent negative
impacts on human health and the environment by properly recycling your product.
Recycling contributes to preserving natural resources. For more information on the recycling of this product,
refer to your local authority, domestic waste processing organization or store, where you purchased the product.
This product complies with EU directive requirements on electromagnetic compatibility and
electrical safety.
The instruction manual is available at website www.ecg-electro.eu.
Changes in text and technical parameters reserved.
Water temperature: 23°C ± 5°C
Up to leg size 49
IPX4 – Protection against spraying water
GB
08/05
33
Tabla de contenido
