Tabla de contenido
USING THE APPLIANCE
Correct use of the product significantly improves the blood circulation n the legs, giving a lasting and pleasant
warm feeling (increase in skin temperature). A regular massage bath can improve blood circulation in the legs
and indirectly to the entire area of the lower limbs.
The built-in heating body under each massage roller keeps the required temperature throughout the whole
period of activation of the device with the rotary switch.
The stimulating points on the surface of the massage device are like gentle fingers caressing your feet and
performing the most effective refreshing and strengthening massage. The effectiveness of the massage can be
controlled by slightly increasing or decreasing the pressure on the foot in the massage area. In addition, there
are air jets on the device that create a warm relaxing bubble bath for your feet.
Running massage
1.
Before connecting the device to the electricity outlet, the rotary control knob must be in the OFF position.
2.
Do not connect or disconnect the device to/from the electricity outlet if your feet are in the water bath or
if your hands are wet.
3.
Place the device on an even surface. The anti-slip rubber feet prevent unwanted movement of the device.
GB
4.
Fill up the massage device with warm water (with the requested temperature); the volume of water should
not exceed the maximum level line. This device is designed to keep the water at a pleasant temperature,
so do not to increase it. Never use the massage device without water!
5.
Sit comfortably, put your feet on the massage rollers and using the rotary control knob, set the desired
mode (vibration massage, bubble massage, massage with or without heating the bath).
Functional modes available:
Warm bath + vibration massage + bubble massage + infra radiation [W + B + M + IR]
To use the foot vibration massage in a stimulating temperature, turn the control knob to the position
[W + B + M + IR].
Warm bath + bubbles [W+ B]
For a relaxing massage in pleasant warm water with a stimulating bubble massage, turn the control knob
to the position [W+ B].
Vibrating massage + infra radiation [M + IR]
To use the foot massage in the water bath, turn the control knob to the position [M + IR].
Ending the massage
•
After ending the massage, first turn the switch to the OFF position then remove your legs and disconnect
the device from the outlet. Do not forget that you must not stand up in the device!
•
When pouring out the water, tilt the device e.g. above the bath, so that the water can run out of the spout.
Using the cosmetic brush
Make sure that the switch is in the OFF position. Insert the batteries into the body of the brush (note the correct
polarity).
Cleaning feet
Make sure that the disk with the brush is correctly inserted in the device (do not use without the disk inserted).
Turn the device on and gently move the brush across the sole, until the dirt is removed.
Do not push too hard otherwise the roller will stop rotating.
Use the speed switch to select low (LOW) or high (HIGH) speed or rotation or completely switch off the device
by moving the switch into the OFF position.
Grinding feet
Exchange the cleaning ring with the grinding disk. Choose either the rough or the fine grinding disk.
Activate the device and gently move with the disk over the hardened skin, which will be gradually sanded until
reaching the required smoothness. Only use on dry skin.
32
Tabla de contenido
