Technical Data - Zanussi ZBT27430SA Manual De Instrucciones

Problem
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
Remove the screw
from the lamp cover.
Remove the lamp
cover (refer to the il-
lustration).
Replace the used
lamp with a new lamp
of the same power
and specifically de-
signed for household
appliances (the maxi-
mum power is shown
on the lamp cover).
Install the lamp cover.
Tighten the screw to
the lamp cover.
Connect the plug to
the mains socket.
Open the door. Make
sure that the light
comes on.

Technical data

Dimension of the recess
Rising Time
Voltage
Frequency
www.zanussi.com
Possible cause
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
Height
Width
Depth
Set a higher temperature.
Set a lower temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1580 mm
560 mm
550 mm
20 h
230-240 V
50 Hz
Solution
9