CleanCraft HDR-H 108-20 Manual De Instrucciones página 26

PROBLEM
Wa t er leak ing fr om
under the high pressure
cleaner.
T h e c l e a n e r s t o p s
w or k ing a n d t h e
warning light (42) is off.
T h e c l e a n e r s t o p s
wo r k i n g a n d t h e
warning light (42) is on.
(warning light (46)) is on.
T h e c l e a n e r r
e s u m e s o p e r a t i o n
spontaneously when it is
in Total Stop mode.
When the master switch
(1) is tur ned on, the
engine hums but does not
start up.
The cleaner does not
deliver hot water
T he cleaner will not
start up again and the
warning light (45) is lit.
T he cleaner will not
start up again and the
warning light (47) is lit.
I n S t eam mode , the
burner does not start or
stops working and the
warning light (48) is lit .
Lamp (49) flashing.
26
CAUSE
Safety valve triggered.
A safety device has been
tripped in the system where
the cleaner is connected (a
fuse, differential switch,
etc.).
The amperometric protector
has tripped.
L eaks and/or dr ips in
the delivery
circuit.
Unsuitable electrical
system and/or extension
lead
There is not enough fuel in
the tank (warning light 44
is lit).
The fuel filter is dirty.
The boiler's safety
thermostat has tripped.
T h e b u r n e r c o n t r o l l e r
h a s tripped (warning light
49 is lit).
The cleaner has been
inactive for
more than 15 minutes and
has entered Timed
Shutdown mode.
Leaks have been detected in
the deliver y circuit
causing the cleaner to
restart several times: the
relative safety device has
tripped causing the
cleaner to stop working.
Pressure above 32 bar/464
psi.
M a l f u n c t i o n i n
s o m e temperature control
evice
SOLUTION
IF THIS HAPPENS PERSISTENTLY DO NOT USE
THE HIGH PRESSURE CLEANER BUT CONTACT A
QUALIFIED TECHNICIAN.
Reset the safety device.
AGAIN , DO NOT USE THE CLEANER AND
CONTACT A QUALIFIED TECHNICIAN.
Follow the instructions in
Inspect the delivery circuit for leaks.
Check the instructions for connecting up to
the mains power supply have been followed
correctly (refer to the
INSTRUCTIONS MANUAL
– SAFE T Y INSTR UC TIONS
regards the use of an extension lead.
Top up with fuel.
Follow the instructions in
MAINTENANCE" .
Leave the cleaner to cool down for a few
minutes so the safety device can reset.
SHOULD IT TRIP AGAIN, DO NOT USE THE
C LE A NE R A N D C O N TA C T A QU A L I FI E D
.
TECHNICIAN
Turn the master switch (1) to "0", wait a few
seconds and then turn it to
SHOULD IT TRIP AGAIN, DO NOT USE THE
C LE A NE R A N D C O N TA C T A QU A L I FI E D
.
TECHNICIAN
Follow the instructions in
CLEANER/INTERRUPTING THE OPERATION –
TIMED SHUTDOWN"
Turn the master switch (1) to "0", wait for
a few seconds and star t up the cleaner
again.
SHOULD IT TRIP AGAIN, DO NOT USE
THE CLEANER AND CONTAC T A QUALIFIED
TECHNICIAN.
Follow the instructions in
CLEANER IN STEAM MODE"
Use the machine only in Cold Water.
CONTACT A QUALIFIED TECHNICIAN.
SHOULD IT TRIP
"SAFETY FEATURES" .
), especially as
"SUPPLEMENTARY
.
"STOPPING THE
"OPERATING THE
.