Shindaiwa T350 Manual De Instrucciones página 9

Install the Cutting Attachment Shield (T350/C350)
Socket-head
Cap Screws
Bracket
Shim
(T350)
Nut
Cutting Attachment Shield
Figure 12
Install the Cutting Attachment
Shield T350/C350.
1. Insert the cutting attachment shield
between the outer tube and the
cutting attachment mounting plate.
See Figure 12.
NOTE:
It may be necessary to loosen the
retaining nut and clamp screw to adjust
cutting attachment shield mounting
plate.
2. (T350 only) Fit the two shims and
the bracket over the outer tube and
loosely install the four socket-head
screws. See Figure 12.
To Change Position of Line Cutter.
The line cutter can be positioned in
2 positions to obtain different line length
for cutting.
1. Remove the 2 hex screws with a 4mm
hex wrench. See Figure 12A.
2. Rotate line cutter. See Figure 12A.
3. Reinstall the two hex screws and
tighten them securely.
Outer Tube
Shim
(T350)
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-
head cap screws.
3. Tighten the four socket-head cap
screws to secure the cutting attach-
ment shield.
WARNING!
NEVER operate the unit without the
cutting attachment shield installed
and tightly secured!
WARNING!
The line cutter is very sharp. Wear
gloves to protect your hands when
handling.
Be careful to not lose the 2 nuts in the
cutting attachment shield, they are not
captured.
Sub-Shield T350/C350.
(when trimmer head is in use)
1. Attach the shield extension to the
Line Cutter
Hex
Screws
Figure 12A
NOTE:
cutting attachment shield.
WARNING!
NEVER use this machine without
sub-shield when using a trimmer
head.
Cutting Attachment Shield
Sub-shield
CAUTION!
Make sure the sub-guard is com-
pletely hooked at the hook receiver.
Hook
Receiver
Hook
9