Shindaiwa T350 Manual De Instrucciones página 10

Installing a Trimmer Head (T350/C350)
NOTE:
The T350 is shipped with Holder A,
the blade retainer (safety clip), Holder
B, shaft bolt, and bolt guard installed.
The shaft bolt is a LEFT-HAND thread.
Remove it by turning CLOCKWISE!
1. With the gearcase output shaft facing
up, rotate the gearshaft and holder A
until the hole in holder A aligns with
the matching hole in the gearcase
flange, and then lock the holder to
the gearcase by inserting the long
end of the hex wrench through both
holes. See Figure 13-A.
2. Using the combination spark plug/
screwdriver wrench, remove the shaft
bolt, bolt guard, holder B and the
safety clip. (The bolt guard, shaft bolt
and safety clip are not used with a
trimmer head). See Figure 13-A.
3. Install Holder B on the gearcase
shaft. The splined hole on Holder B
must engage with the gearcase shaft.
4. Using the hex wrench to secure
Holder A , install and hand-tighten
the trimmer head (counter-clockwise
to install). See Figure 13-B.
5. Remove the hex wrench from the
gearcase and holder.
The T350 should now be completely assembled and ready for use as a grass trimmer.
10
A
Shaft Bolt (not
Bolt Guard (not
used)
Safety Clip
(not used)
35007
Figure 13
WARNING!
A standard grass trimmer unit with loop
handle should NEVER be operated
with blade-type attachments. For blade
use, the trimmer must be fitted with a
bicycle-type handlebar or barrier bar
that is located in front of the operator to
reduce the risk of the operator coming
in contact with the cutting attachment.
(Per ANSI B175.3). When using a
blade, the unit must also be equipped
with a harness or strap.
B Hand-tighten Trimmer Head (coun-
ter-clockwise to install)
used)
Holder B
Holder A
Gearcase
Shaft
35008
Hex Wrench