Speaker Setup; Rear Panel - Phonic Powerpod 620 R Manual Del Usuario

9. EFX (Effect) Outputs
These 1/4" TS outputs are the final output
from the EfX send mix. This feed may
be used to connect to an external digital
effect processor, or even to an amplifier
and speakers, depending on your desired
settings.
10. Foot Switch Jack
This port is for the inclusion of a non-latching foot switch, used to
remotely adjust properties of the built-in Digital Effect processor.
The Powerpods 620 R and 740 R both feature a single foot switch
jack, which allows the user to remotely turn on and off the digital
effects.

Rear Panel

11. Speaker Outputs
These jacks are used to connect to speakers, fed from the internal
power amp. They consist of 1/4" Phone Jacks on both models.
The Amp Select switch (on the front of the mixer) determines the
operation of these jacks. If the Amp Select switch is set to "Main
1/Main2" or "Main / Moni", a single speaker with a 4 to 8 ohm load
can be connected to jack A on both the Main 1 and Main 2 speaker
outputs. You can also connect two speakers with impedances
between 8 and 16 ohms to both jacks A and B of the Main 1/2
speaker outputs. When using Bridge Mono mode, use the Speaker
Output labeled "Bridge (L+R)" only to connect a Speaker with
a loading between 8 and 16 ohms. Refer to the Speaker set up
chart to the right for a more detailed indication of how to connect
speakers.
NB. Due to the fact that the signal has been processed by the power amp,
these ports should be used in conjunction with passive speakers only to avoid
damaging any other equipment.
6
11
SPE A K ER SETUP

10
Using speakers with an incorrect loading can not only cause
distortion, but also irreversible damage to the powered mixer.
Please ensure the loadings of your speakers are consistent
with those shown above.
POWERPOD 620 R / POWERPOD 740 R
Not used
Not used
Not used Not used