Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Shipping Brace Removal
Make sure the tractor's engine is OFF, remove the ignition key, and set the parking
brake before removing the shipping brace. Refer to the Controls & Operations
section on page 16 for instructions on how to set the parking brake.
Check the cutting deck for a shipping brace (a) that may be holding the chute
deflector (b) upward for shipment. If the shipping brace (a) is present, it must be
removed before operating the tractor. Holding the chute deflector (b) fully upward,
remove the shipping brace (a). Lower the chute deflector (b) and discard the
shipping brace (a). See Figure 2-3.
(b)
The shipping brace (a) is used for packaging purposes only, it must be
removed and discarded before operating your tractor.
The cutting deck is capable of throwing objects. Failure to operate the
tractor without the chute deflector in the proper operating position could
result in serious personal injury and/or property damage.
ASSEMBLY & SET-UP
WARNING
Figure 4
WARNING
WARNING
Attaching the Steering Wheel
1.
If the steering wheel (a) for your tractor did not come attached, the
hardware for attaching it has been packed within the steering wheel (a),
beneath the steering wheel cap (b). Carefully pry OFF the steering wheel cap
(b) and remove the cupped washer (c) and hex bolt (d). See Figure 5.
(b)
(a)
2.
With the wheels of the tractor pointing straight forward, place the steering
wheel (a) over the steering shaft (e). See Figure 5.
3.
Place the cupped washer (c) -- cupped side down -- over the steering wheel
(a) and secure with the hex bolt (d). See Figure 5.
4.
Place the steering wheel cap (b) over the center of the steering wheel (a) and
push downward until it "clicks" into place. See Figure 5.
Attaching the Seat
If the seat for your tractor was not attached at the factory, refer to the following steps.
NOTE: For shipping reasons, seats are either fastened to the tractor seat's pivot
bracket with a cable tie, or mounted backward to the pivot bracket. In either case,
remove the seat from its shipping position.
11
(d)
(c)
(a)
(e)
Figure 5
Tabla de contenido
Solución de problemas
