Mediclinics M17A Manual De Instalación Y Utilizacion página 15

www.mediclinics.com
Fig. 1
Fig. 2
Fig. 3 Fig. 4
The appliance's electrical installation is made via rear channelling (figure nº 5),
as follows:
Fig. 5
1. Drill four Ø 8 mm (Ø 0.31") holes using the supplied template. Clean up the
holes once they have been made. Insert the four plugs until they are flush with
the surface (see figure 6).
2
2. Pass the 3 electric cables (3 cables 16 AWG 1.31 ����
) from the wall
through the entrance hole (Ø 22 mm - Ø 0.87") as figure nº 8 shows.
Means for disconnection with disconnection under
overvoltage category III.
During the installation process, the protection
areas should be considered according to
Standard VDE 0100.