Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Moving the saw straight at a constant speed will
produce optimum cutting.
CAUTION:
G Before starting to saw, ensure that the saw
blade has reached full speed revolution.
G Should the saw blade stop or make an abnormal
noise during operation, turn off the switch
immediately.
G During operation, do not cover the slots in the
tail to prevent motor burn.
G Always take care in preventing the power cord
from coming near the revolving saw blade.
G When finished with a job, pull out the plug from
the power receptacle.
POCKET CUTTING
CAUTION:
G Release trigger after cutting work and
disconnect plug from power supply before any
adjustment.
G Never tie or wedge the safety cover in a raised
position.
1. Mark the desired cutting area clearly with lines
all side. (See Fig. 11)
2. Set depth adjustment according to material to
be cut.
3. Push the safety cover lever all the way back so
the blade is exposed as shown in Fig. 11.
4. Tilt saw forward and align the notch (Fig. 10)
with the pre-marked guide line.
5. Release the safety cover lever. When the safety cover contacts the workpiece surface, it
will be in proper position to open freely when cutting is commencend.
6. Holding the saw in position, with the blade not contacting the workpiece surface, pull the
trigger.
7. After the saw has reached full speed, gradually lower rear end of the saw until its base
rests on the work surface.
8. Advance saw along the cutting line up to the corner.
9. Release trigger and allow blade to stop completely before withdrawing the blade from
the workpiece.
Never under any circumstances pull the saw backwards while the blade is in motion, as
kickback may result.
10. Use a jig saw or hand saw to cut the corners out clean.
11. When starting each new cut, repeat as above.
When Inclined 45°
Fig. 10
Fig. 11
English
When
not
Inclined
Lever
15
Tabla de contenido
