Accessmatic Avanti 4000Z Manual De Usuario página 40

vanti
installation of controller
1. Put respectively four square screws in grooves number 1 and 2 before
installing the controller.
2. Put 4 nuts on to controller, move the controller to the correct position and
tighten bolt.
Installation of idler pulley
1. Put three square screws in groove number 2 before installing the idler pulley
(If place in groove number 1 groove, the driving wheels on the pulley and
motor are not in a straight line, which will cause wear and distortion for belt,
and even cause the belt fall o .)
2. Connect the pulley main body with three square screws. Place spring
washers and slightly tighten nuts.
3. Lossen four screws like A and socket head screw B.
4. Place the belt on the driving wheels of the motor and the pulley. Adjust the
position of the pulley's three square screws on the track, then tighten.
13. Installation of belt connect plate
1. Lossen the screw A and remove The B.
2.Move two outer door leaf to close position.
3.Adjust position of inner door leaf, make. the overlap distance of inner door
and outer door among 3-5CM (at same side).
4. Belt let into B according to the position of C.
5. Fix B to C by tighten screw A.
Screw A (M5)
Opening your life
Belt
12