Safety Signs; Product Identification Label; Main Components - GGP ITALY B 26 J Manual De Instrucciones

3.1.3 User types
This machine is intended for use by
consumers, i.e. non-professional operators.
The machine is intended for "DIY" use only.

3.2 SAFETY SIGNS

The machine has various symbols on it
(fig. 2). They are used to remind the operator
of the behaviour to follow to use it with
the necessary attention and caution.
Meaning of symbols:
WARNING! DANGER! Failure to
use this machine correctly can be
hazardous for oneself and others
WARNING! Read the instruction
manual before using the machine.
Anyone operating the machine
under normal conditions for
continuous daily use may be
exposed to a noise level equal
to or exceeding 85 dB (A). Wear
ear protectors, safety goggles
and a protective helmet.
Wear gloves and safety boots!
PROJECTION HAZARD! Keep
any people or pets at least 15 m
away when using the machine!
Maximum cutting means speed.
Do not use circular saw blades.
Danger: Using circular saw
blades on models that are not
designed for them exposes
the user to the danger of very
serious or even fatal injuries.
WARNING! Petrol is flammable.
Allow engine to cool at least 2
minutes before refuelling.
Beware of blade thrust.
WARNING! - Keep away
from hot surfaces.
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an authorised assistance centre.

3.3 PRODUCT IDENTIFICATION LABEL

The product identification label holds
the following data (fig. 1 ):
1. Sound power level
2. Conformity marking
3. Year of manufacture
4. Manufacturer's reference model
5. Type of machine
6. Serial number
7. Name and address of Manufacturer
8. Emission number
9. Article code
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an authorized service workshop.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is made up of the
following main components (fig. 1 ):
A. Engine
B. Drive tube
C. Cutting means
1. Cutting line head
2. 3-point blade
D. Cutting means guard
E. "MONO" front handle
F. "MONO" rear handle
G. Leg guard barrier
H. "DUPLEX" handle bar
EN - 5