Removing The Infant Carrier Adaptors; Removing The Travelsystem Adaptors; Removing And Mounting The Cover; Removing And Mounting The Belt System - Kiddy City'n Move Manual De Uso

EN
Push the handle forward until the buttons lock in place (fig. 20; no. 2).
WARNING
Ensure before using that the adaptors and the infant carrier
are engaged!
To remove the Kiddy infant carrier push both handle buttons and pull the handle back
in to an upright position.
WARNING
Ensure that both handle buttons are engaged.
Now the infant carrier can be removed from the adaptors.

5.4 Removing the infant carrier adaptors

Push in and hold the removing button on the travelsystem adaptor (fig. 21, no. 1) and
pull out the infant carrier adaptor (fig. 21, no. 2).
Remove the second infant carrier adaptor in the same manner.

5.5 Removing the travelsystem adaptors

Push the opening button on the travelsystem adaptor upwards (fig. 22; no. 1) and
open the flap (fig. 22; no. 2). Afterwards detach the travelsystem adaptor from the
chassis (fig. 22; no. 3).
Remove the second adaptor in the same manner.

6. Removing and mounting the cover

6.1 Removing and mounting the belt system

Push the plastic clips on the end of the 5 belts from underneath the seat through the
holes to the front (fig. 23).
29
Mount the belt system by pushing the clips through the holes and make sure that
they lay flat on the rear of the backrest and the seat.
WARNING
Never use the stroller without the belt system.
WARNING
Make sure that the belts are not twisted and placed into the
correct holes.
6.2 Removing and mounting the cover
Remove the sunroof like like described in section 3.3.
Remove the belt system like described in section 6.1.
To remove the seat cover open 6 snap fasteners at the side of the seat and backrest
(fig. 24 no. 1–6). Open the snap fasteners on the second side also.
Now pull off the cover from the upper part of the backrest (fig. 25) and from the foot
rest.
To mount the cover follow the steps for removing in reverse order!
WARNING
Don't forget to mount the belt system (see section 6.1)

7. Care and maintenance

7.1 Care and maintenance of the chassis

Periodically check the chassis for loose screws, rivets or worn out or defective parts.
Check the fabric cover and belts for open seams or other defects.
Don't use the stroller when you noticed a defect. Defective parts have to be changed
or repaired before using the stroller again. If a wheel is squeaking, spray some liquid
silicone lubricant on the axles. Wipe off unnecessary lubricant.
EN
30