Operation; During Operation; Maintenance; Maintenance Table - THERMOBILE ISA 65 Manual Del Usuario

the continuous mode. The fan starts directly.
CAUTION
Do not switch the heater to one of the
heating positions when the fuel hose is
not connected, nor when the connected
fuel tank is empty.
3. Set the room thermostat, if applicable.
Power up for ventilating:
1. Set the rotary switch (A) to the "1" position (Fig.
6). The fan starts blowing.
4

OPERATION

4.1 During operation

Description
Check the pump for leakage, corrosion and filthiness.
Check the pump, fans, ignition, photocell, burner, electrical
installation and heat exchanger for general condition.
Check the fuel line for obstruction, corrosion and leakage.
Check the fan of the burner for corrosion and filthiness.
Check the fan for corrosion and filthiness.
Clean the filters of the pump, magnetic valve.
Check the photocell for damage. Make sure the photocell
is free from dust and sediment.
Check the adjustment of the electrodes.
18
Power down for heating:
Uitschakelen van verwarming:
1 Set the rotary switch (A) to the "0" position (Fig.
6). The magnetic valve closes to stop the fuel
supply.
2. Disconnect the electric power.
Power down for ventilating:
1.
6).
2. Disconnect the electric power.
5

MAINTENANCE

5.1 Maintenance table

Record the maintenance in the table at the back
of this book after each winter season.
Period
Yearly
User
Dealer
User
User
User
Dealer
User
User
40.021.073-rev00-2014
HOT
Do not touch the flue with rain cover, nor
the air outlet! The flue with rain cover
and the air outlet become hot during
operation!
CAUTION
After you switch off the heater, the fan still
rotates. The fan cools the heater to avoid
damage caused by overheating. The fan
stops automatically. Do not remove the
plug from the socket until the fan fully
stops!
Set the rotary switch (A) to the "0" position (Fig.
Biennial
ENGLISH
ISA 65