Urrea UD85 Manual De Usuario Y Garantía página 31

will begin to blink and the arrow at the
right of the bar graph will come on. This
indicates that the value you will put in is the
HI (high) reference value.
Using the arrow ( , ,
enter HI (high) reference value that you
want your readings to be compared to. Use
the HOLD button to select "
Once the HI (high) reference value is entered
(stored), press the HI/LO (Range button) to
enter the LO (low) reference value into the
meter.
When you press the HI/LO button, the arrow
at the left of the bar graph will come on.
This indicates that the value you will put
in is the LOW (low) reference value. Using
the arrow ( , , and
HOLD button enter the LO (low) reference
value that you want your readings to be
compared to. Press the EDIT button to exit
this mode.
7. (Select the Manual Range
mode in the Non Editing mode;
Enables the Meter to store the HI
(high) reference value or the LO
(low) reference value in the Compare
mode.)
Press the RANGE button to select the
Manual Range mode ant turn off the "AT"
Autoranging symbol, (The meter remains in
the range it was when manual ranging was
selected.)
Each time you press the RANGE button in
the Manual Range mode, the range
increases and a new value is displayed. If
you are already in the highest range, the
meter wraps around the lowest range. To
exit the Manual Range mode and return
to autoranging, press and hold down the
RANGE button for 2 seconds. The "AT"
symbol turns back on. When the range
and ) buttons
" sign.
) buttons and the
is changed manually, the Recording,
Percentage (%), Compare, Relative and
Hold modes are disabled.
Press the HI/LO button to enable the Meter
to edit and store the HI (high) reference
value or the LO (low) reference value by
toggling between the 2 reference values
when the Meter is in the Compare mode.
Press the HI/LO (RANGE) button to recall
the stored reference value in the Compare,
Relative or Percentage mode.
8 – (Maximum, Minimum,
and Average Recording; A Left-Shift
button when the Meter is in the
Editing mode).
Press the REC button to enter the Recording
mode. The " " symbol turns on. This
function allows you to record Maximum,
Minimum and Average values for a series
of measurements on the same function
and range. This Meter will beep every
time a new maximum or minimum value
is recorded. Press the REC button to scroll
through the stored MAX, MIN and AVG
values. When an overload is captured, a
beeper tone emits and the Meter displays
OFL (overload). This Meter can only record
for 24 hours in this mode.
When this Meter entered the Recording
mode, Auto Power Off is disable and this
Meter will automatically switch to Standby
Mode after around 1 hour to save battery
life unless you disabled the Standby Mode.
To disable the Standby Mode, turn the
rotary switch from OFF to any function (ON)
position while holding down the HOLD
button.
If you press any ineffective button to the
Recording mode, the Meter will sound 2
consecutive beeps to let you know that
the button function does not work in the
E N G L I S H
31