Comfort Profiles; List Of The Service Parameters - FEIG Electronic Sensors Instrucciones De Manejo

P. Setting Function
range
r 0 ... 4 Relay function
.
0 ... 1 Relay operating
o
.
mode

13 Comfort profiles

Independently of the opened channel, profiles set the parameters for the channel functionality and for the
relay functionality for both channels simultaneously.
P. Setting Function
range
P 0 ... 9 Profiles
.
IMPORTANT
Restoring the parameters to the factory settings is done using the parameter "Profiles" with a
parameter value of "1". Alternatively, factory settings can be restored by pressing both buttons on
the case when switching on the power supply of the device.

14 List of the service parameters

P. Setting Function
range
A . 1, 3, 5, 7, Device Address
9,
b, d
FEIG ELECTRONIC GmbH
Manual
Description / note
This setting assigns the channels 1 and 2 to both available
voltage-free relays. Combinations are also possible.
0: off
1: channel 1 (for channel 1)
2: channel 2 (for channel 2)
3: channel 1 OR channel 2
4: channel 1 AND channel 2
The logical switching behaviour per channel of the relays
can be specified with this parameter.
0: open circuit current principle
1: no-load current principle
Description / note
Several parameters are set simultaneously to frequently
occurring convenience functions with profiles.
1: factory setting
2 ... 9: parameter profile 2 to 9 (see Chapter 16)

If a parameter is subsequently modified so that it is
different from the profile settings, this is indicated by
displaying the value "0".
Description / note
This parameter specifies the device address for channel 1.
Only odd numbered addresses can be input for channel 1.
The next higher even number is then automatically assigned
to the second channel.
Address
Channel 1 / Relay 1
Channel 2 / Relay 2
Page 38 of 97
1 3 5 7 9 B D
1 3 5 7 9 B D
2 4 6 8 A C E
MWD BP_Handbuch_mehrsprachig_10.doc
MWD BP
Factory
setting
Relay 1 =
1
Relay 2 =
2
0
Factory
setting
1
Factory
setting
1