Preparation Of Top Cabinet; Assemble And Install Adaptor; Mount The Oven; Important - GE JVM3162 Instrucciones De Instalación

A2. USE TOP CABINET TEMPLATE FOR

PREPARATION OF TOP CABINET

You need to drill holes for the top support screws, a hole
large enough for the power cord to fit through, and a
cutout large enough for the exhaust adaptor.
•
Read the instructions on the TOP CABINET
TEMPLATE.
•
Tape it underneath the top cabinet.
•
Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION:
when drilling holes in the cabinet bottom.
ASSEMBLE AND INSTALL
A3.
ADAPTOR
NOTE: On some models, the exhaust adaptor and damper
assembly may already be assembled to the oven.
1
Place the oven in its upright position, with the top of
the unit facing up.
NOTE: Make sure the blower fan blades are visible
and are pointing up.
2
Insert the tabs on each side of the damper into the
holes at the inside rear of the adaptor.
3
Attach the exhaust adaptor to the blower plate with
the two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
oven is installed.
Installation Instructions
Wear safety goggles
Damper
Exhaust
Adaptor
Blower Plate
Back of
Oven
A4.

MOUNT THE OVEN

FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting the
oven, thread power cord
through hole in bottom
of top cabinet. Keep it tight
throughout Steps 1–3.
Do not pinch cord or lift oven
by pulling cord.
2 Rotate front of oven up
against cabinet
bottom.
13
1
Lift oven, tilt it
forward and hook
slots at back bottom
edge onto two lower
tabs of mounting
plate.