General Directions - Gedy 2454 G-BORA Manual De Instrucciones Para La Instalación Y El Uso

Elektrischer händetrockner mit öko-jet-fotozelle
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
It will be simply needed to remove the cover that blocks the photocells to ensure the dryer to resume its normal
function in 3-4 seconds.
Resistance and motor are equipped with automatic reset thermostats, which temporarily disable the operation of
the element in case of danger or overheating.
MANTAINANCE
Warning: Before performing any mantainance, please disconnect the appliance from the network.
Clean this dryer using a soft cloth dampened with water and detergent.
To ensure the durability and reliability of this product, periodically check that the grid inlet and outlet of the cone
are not clogged by dust or any equivalent material.
NEW
FILTER
FILTER EPA E11 filter paper
FILTER
TO REPLACE
The Hepa filter inside the machine, if present, guarantees air to be cleaned from excessive
dust and dirt.
The filter must be periodically cleaned with a jet of compressed air at a distance of about
20 cm. If the filters are soiled and/or damaged to the point that they cannot be cleaned
or recovered, replace them immediately, regardless of the time that has elapsed. See, for
example, the image on the side:
The quality E11 EPA filter paper, if maintained in good condition and replaced as required above,it is able to protect
against bacteria and external factors that can go up to 97.66% of airborne particles.
WARNING: Failure to clean the filter will result in major engine fatigue (as it will work with the suction in the dirty
filter) and the possibility of engine failure due to overloads, which the manufacturer can not charge for warranty.
PROCEDURE FOR CLEANING AND MAINTENANCE OF THE FILTER:
BEFORE REMOVING THE FILTER LOOK AT WARNING AS REQUIRED ON THE POSITION PLATE ON THE FRONT OF THE ENGINE COVER:
WARNING: DANGER: air inlet zone, disconnect from power supply before changing filter. Do not place hands near
suction zone.
PROCEED THEREFORE TO REMOVE, CLEAN AND
REFILL THE FILTER IN OUR HEADSELF AS IMPROVED IMAGE.
WARNING AT THE SIDE INDICATED AS "ALTO"
BRUSH MOTOR (carbon brushes)
The motor brushes cartridges in the drive unit has a life of about 1000 hours of effective operation. The duration
of the same varies depending on the conditions of use and of cleaning the filter and general mantainance of the
appliance. It is needed to contact the service in order to restore the brushes at the end of the cycle.
This maintenance does not come under warranty, as it is comparable to the oil consumption in the engine of a
machine, which is always the responsibility of the user. Once the carbon brush couple is exhausted, the engine stops
and can no longer leave.
UV LAMP
The appliance is equipped with a UV lamp for continuous air cone disinfection. The LED lamp is always in operation
and does not require maintenance.UV Led is said by produce, to be lasting about 100.000 hours.

GENERAL DIRECTIONS

Do not use this product for a different function from that to which it is intended: hand dryer.
• Do not leave the appliance exposed to atmospheric conditions such as rain, sun, etc..
• Make no changes of any kind to the device
• Do not obstruct the air outlet or mouth
• Do not insert any object into the grid or the outlet air
In case of failure and / or malfunction, remove the mains and consult with the manufacturer or dealer.
GUARANTEE
This apparatus is subordinated to guarantee of duration of 3 years beginning from the purchase date, to be proved
8
Tabla de contenido
loading

Tabla de contenido