Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR INSTALLERS
THIS HAND DRYER HAS TO BE FIXED AT PROPER DISTANCE OF AT LEAST 80 CM
FROM BATHTUB OR SHOWER OR WASHBASIN.
Please verify that the electrical capacity of the system and the female plugs of current is adapted to the maximum
power of the apparatus. It is necessary to provide for the unit a switch of a twopole switching device with contact
separation of 3 mm.
We suggest installing at least 120cm from ground, by airoutlet distance, and at least 40 cm far away from
reflecting surfaces (washbasin) to avoid bed functioning.
For assembly, use the attached assembly sheet and the dowels and screws included in the package.
- Fix the supplied template to the wall, following the instructions provided. (fig. 1)
- Drill at the 6 points indicated. (fig. 2)
- Open the wall base by unscrewing the two screws located in the front, using a cross-tip screwdriver. (fig. 3)
- Install the back portion to the wall at the desired height using the 6 screws and dowels included in the package. (fig. 4)
Reposition the front portion on it and lock it with the two screws removed previously. (fig. 5)
If the power cord is damaged should be replaced by the manufacturer or person with similar technical
qualification, to prevent any risk.
OPERATION
Photocell models
The hand dryer comes into operation and automatically stops by hands approaching and moving away from the
cone air outlet.
Warning: In case of an overload of internal temperature, a thermostat with automatic reset protection suspend the
operation of the engine.
This device gives the user greater safety of operation.
The appliance is equipped with electrical resistance. The air is then heated thanks to the power of the motor and the
resistance. However, it is possible to disable the resistance using the switch placed inside the device on the electronic
board. This allows a lot of energy savings compared to traditional electric towels, especially in high-powered areas,
reducing consumption as per our commercial indications (only 550Watts absorbed in place of 1100Watts with active
resistance). The first daily use with deactivated resistance may therefore give the impression of cold air, but the same
will heat up to come running from the second drying cycle. The engine and its copper structure keep the heat for
several hours and thus guarantee hot air under constant use. If the use is sporadic or the weather is very harsh it is
advisable to keep the resistance always active.
The device is also equipped with an internal air intake disinfection system by means of a UV light bulb which is
always active, since the actual effectiveness of an UV lamp is achieved only with the continuous exposure of the
internal materials to the ultraviolet rays. The lamp guarantees the total reduction of the internal bacterial charge in
the air cone area, along with the EPA filter, a clean air supply on your hands. See the specifications for the filter below.
MANTAINANCE
Attention: before executing any maintenance operation, unplug the apparatus from the electrical network.
Clean the appliance by damp cloth with water and detergent. To ensure the durability and reliability of this product
periodically check that the grid inlet and outlet of the cone are not clogged by dust or any equivalent material.
The appliance is equipped with electrical resistance. The air is then heated thanks to the power of the motor
and the resistance. However, it is possible to disable the resistance using the switch placed inside the device
on the electronic board. This allows a lot of energy savings compared to traditional electric towels, especially
in high-powered areas, reducing consumption as per our commercial indications (only 550Watts absorbed in
place of 1100Watts with active resistance).
The first daily use with deactivated resistance may therefore give the impression of cold air, but the same will
heat up to come running from the second drying cycle. The engine and its copper structure keep the heat for
several hours and thus guarantee hot air under constant use. If the use is sporadic or the weather is very harsh
it is advisable to keep the resistance always active.
SECURITY SYSTEM
The device has a system that prevents vandalism continuous operation, caused for example by covering the
photocell.
If this occurs, the dryer can work without interruption for about 60 seconds, then automatically stops waiting for (stand by).
7
Tabla de contenido
