Store The Machine; Troubleshooting - GreenWorks PWA201 Manual Del Operador

6.2

STORE THE MACHINE

WARNING
Make sure that the spray gun, the high pressure hose and the
pump are dry.
WARNING
Make sure the machine is out of the reach of children.
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
• Disconnect the garden hose from machine.
• Wind the power cord and the high pressure hose.
• Clean housing and the plastic components with a moist
and soft cloth.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• If needed, call the customer service phone number
(enter number here) for servicing instructions.
• Store the machine in a dry, isolated and frost-free area.
7

TROUBLESHOOTING

PROBLEM POSSIBLE
CAUSE
The motor does The power button
not start. is in the "OFF"
(O) position.
The power cord is
not plugged in.
Electrical outlet
does not supply
sufficient power.
The circuit breaker
is tripped.
The power switch
is on, but you do
not pull the spray
gun trigger.
NOTE
SOLUTION
Set the power
switch to the
"ON" ( | ) posi-
tion.
Connect the power
cord to the power
supply.
Try another elec-
trical outlet.
Let it cool, and
start the machine
again.
Pull the spray gun
trigger.
English
PROBLEM
The machine does
not reach high
pressure.
The output pres-
sure varies high
and low.
11
POSSIBLE SOLUTION
CAUSE
The diameter of Replace with a 1"
garden hose is too (25 mm) or 5/8"
small. (16 mm) garden
hose.
Water supply is re- Check garden hose
stricted. for kinks, leaks,
and blockage.
The water supply Open the water
is not sufficient. supply fully.
Spray tip has not Install desired
be installed onto spray tip to end of
the spray wand wand.
properly.
The water intake Remove filter and
filter is clogged. rinse in warm wa-
ter.
The water supply Open water supply
is not sufficient. fully. Check gar-
den hose for kinks,
leaks, or blockage.
The pump is draw- 1. Make sure that
ing in air. the hoses and
fitting are air-
tight.
2. Turn "OFF"
machine.
3. Purge pump
by squeezing
trigger gun un-
til a stead flow
of water
comes out the
spray tip.
The water intake Remove the filter
filter is clogged. and Rinse in warm
water.
The supply volt- Make sure that on-
age is low. ly the pressure
washer is running
on the circuit.
The gun, hose or Run distilled vine-
nozzle are calci- gar through deter-
fied. gent tank.
EN