Changing The Tool - Bosch GOP Professional 30-28 Manual Original

The given vibration level and noise emission value represent
the main applications of the power tool. However, if the
power tool is used for other applications, with different ap-
plication tools or is poorly maintained, the vibration level
and noise emission value may differ. This may significantly
increase the vibration and noise emissions over the total
working period.
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
This may significantly reduce vibration and noise emissions
over the total working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and application tools, keeping the hands warm,
and organising workflows correctly.
Fitting
Pull the plug out of the socket before carrying out any
u
work on the power tool.
The following table shows examples of application tools. You can find additional application tools in Bosch's extensive range of
accessories.
Application tool
Bi-metal segment
saw blade
Sanding plate for
Delta series 93 mm
sanding sheets
Profile sander
Bi-metal plunge cut
saw blade for wood
and metal
HCS plunge cut
saw blade for wood
Bosch Power Tools

Changing the tool

Wear protective gloves when changing tools. There is
u
a risk of injury when touching the application tools.
Selecting an application tool
Please observe the application tools intended for your power
tool.
Application tool
Material Application
Wood-based materials, Separating cuts and plunge saw cuts;
plastic, non-ferrous including sawing close to edges, in corners and in difficult-
metals to-reach areas;
example: Shortening skirting boards that are already in-
stalled or door frames, plunge cuts when adapting floor
panels
Depends on the sanding Sanding surfaces at edges, in corners or in difficult-to-
sheet reach areas;
depending on the sanding sheet, e.g. for sanding wood,
paint, varnish, stone;
fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnish, polishing felt for pre-
polishing
Wood, pipes/profiles, Convenient and efficient sanding of profiles up to a dia-
paint, varnish, filler, metal
meter of 55 mm;
red sanding sheets for sanding wood, pipes/profiles, var-
nish, filler and metal
Softwood, soft plastics, Small separating cuts and plunge cuts;
plasterboard, thin-walled example: Cutting a recess for sockets, cutting a copper
aluminium profiles and pipe so that it is flush with a surface, making plunge cuts in
non-ferrous metal pro- plasterboard
files, thin sheet metal,
Delicate adaptation work in wood;
non-hardened nails and
example: Sawing recesses for locks and fittings
screws
Wood-based materials, Separating cuts and plunge saw cuts;
soft plastics including sawing close to edges, in corners and in difficult-
to-reach areas;
example: Thin plunge cut in solid wood for installing a
ventilation grille
English | 19
GOP 30-28 GOP 55-36
GOP 40-30
1 609 92A 49C | (11.06.2018)