Faro OVNI Manual De Uso página 31

INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA
SICHERHEITSHINWEISE / VEILIGHEIDSINSTURCTIES INSTRUZIONI DI SICUREZZA
2. Installing receiver in mounting Bracket:
A. Safety precautions:
.Warning: High Voltage: Disconnect source of electrical power by removing fuse or switching off circuit
breaker.
B. Electrical connections:
Make connections as follows, using the terminal block supplied (Fig. 3).
Connect green ground wire to BARE (ground) wire.
Connect blue control unit wire to; blue supply wire. LN
Connect brown control unit wire to brown supply wire.
Connect blue control unit wire (MOTOR N) to blue fan wire.
Connect brown control unit wire (MOTOR L) to brown fan wire.
Connect black control unit wire(for LIGHT) to orange or red fan wire. (light)
If wires are different in colour, or you do not feel confident in wiring your fan yourself, have this unit installed
by a qualified licensed electrician
3 Push all connected wires up into junction box.
4. Slide the receiver in the mounting braked (fig. 4) and extend antenna along side mounting braked.
5. Reinstall the canopy on the mounting braked.
6. Operating transmitter:
A. Install 9 volt battery (not incl.) to prevent damage to transmitter, remove the battery if not use for
long periods of time.
B. Store the transmitter away from excess hat or humidity.
C. This remote control unit is equipped with 16 code combinations to prevent possible interference
from or to other remote units such as garage door openers, car alarms or security systems. If you
find that your fan and light kit go on and off without using your remote control, simply change the
combination code in your transmitter and receiver.
D. Operations buttons on the transmitter:
HI: for fan high speed
MED: for fan medium speed
LOW: for fan low speed
OFF: for fan speed off
LIGHT: for light brightness and off.
The light function is controlled by pressing the light button. Hold button down to increase or decrease
light. Tap button quickly to turn light off or on.
Keep pressing the button for more than one second, the light becomes dimmer and varies cyclically
from dim t bright and back again.
The light button has auto return so it will stay at the same brightness as the last time it was turned
off.
Faro
- 30 -