Installing The Fan - Faro OVNI Manual De Uso

INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA
SICHERHEITSHINWEISE / VEILIGHEIDSINSTURCTIES INSTRUZIONI DI SICUREZZA
PREPARATION:
Verify you have all parts before beginning the installation. Check foam insert closely for missing parts.
Remove motor from packing. To avoid damage to finish, assemble motor on soft padded surface or use
the original foam inset in motor box.
Do not lay fan on its side as this could result in shifting of motor in decorative enclosure.
INSTALLING THE MOUNTING BRACKET:
Caution:
To avoid possible electrical shock, be sure electricity is turned off at the main power box before writing. All
wiring must be in accordance with National and Local Electrical Codes and the ceiling fan must be
grounded as a precaution against possible electric shock.
1- Locate ceiling joist where fan is to be mounted, being sure location agrees with the requirements in the
minimum clearance safeguards section of the guide. Wood joist must be sound and of adequate size to
support a 35- Ib load.
2- If not already present, mount a UL listed outlet box marked "suitable for fan support" following the
instructions provided with the outlet box. The outlet box must be able to support a minimum of 35 Ibs.
3-Attach hanger bracket to outlet box using 2 machine screws provided with the outlet box(Fig.1)
Hanger bracket
Spring washer
Screw

INSTALLING THE FAN

ATTACHING DOWNROD, CANOPY AND COLLAR COVER (FIG.2)
1. Remove ball from downrod by loosening set screw in the side of the ball. Slide ball down and remove
ball pin; remove ball.
2. Feed the 3 wires from top of fan through either end of downrod and set end of downrod into mounting
collar.
3. Insert downrod pin through holes in mounting collar and downrod; slip cotter pin through small hole in
end of downrod pin in place.
4- Tighten security screws against downrod using a large flat blade screwdriver to ensure a tight fit against
downrod.
NOTE: Fan has 6 feet of hook-up wire in case you are using an extension downrod. Wires can be cut so
only 8 inches or so extend beyond the top of the downrod to make the electrical connections easier and
safer.
5- Feed wires through collar cover and slide collar cover over downrod to top of fan. Connect wires (A)
from top of fan to wires (B) in collar cover by snapping two halves of wiring harness together. ( Align 2
ridges and grooves inside connectors- they will only snap together one way.) Secure collar cover to
downrod with set screw on top edge of collar cover.
6- Feed wires through canopy and slide canopy over downrod to lay on top of collar cover. It will be
attached to ceiling later.
7- Feed wires throught ball and slide ball over downrod, past hole in end of downrod. Insert ball pin
(removed in Step 1), slide ball up and tighten ball's set screw to secure ball in place.
Faro
- 27 -