Milwaukee 2601-059 Manual De Instrucciones página 17

Selecting Drill or Drive Action (Cat. No. 2601-059)
1. To use the drilling mode, rotate
the torque selector collar until the
drill symbol
with the arrow.
2. To use the driving screws mode,
rotate the torque selector collar
until the desired clutch setting ap-
pears in line with the arrow. The
adjustable clutch, when properly
adjusted, will slip at a preset torque
to prevent driving the screw too
deep into different materials and
to prevent damage to the screw
or tool.
Selecting Hammer, Drill or Drive Action
(Cat. No. 2602-059)
1. To use the hammer-drilling
mode, rotate the application
selector collar until the hammer
symbol appears in line with
the arrow. Apply pressure to the
bit to engage the hammering
mechanism.
NOTE: The number selected on the torque collar
has no effect on operation of the drill in hammer
mode.
NOTE: When using carbide bits, do not use wa-
ter to settle dust. Do not attempt to drill through
steel reinforcing rods. This will damage the
carbide bits.
2. To use the drilling only mode,
rotate the application selector
collar until the drill symbol
appears in line with the arrow.
NOTE: The number selected on
the torque collar has no effect on
operation of the drill in drilling
mode.
3. To use the driving screws mode
rotate the application selector
collar until the drive symbol
appears in line with the arrow.
Then rotate the torque selector
collar until the desired clutch set-
ting appears in line with the arrow.
The adjustable clutch, when properly adjusted,
will slip at a preset torque to prevent driving the
screw too deep into different materials and to
prevent damage to the screw or tool.
appears in line
The torque specifications shown here are ap-
proximate values.
Torque selector
collar setting
2-6
8-10
12-14
16-18
1
20-22
2
Torque selector
collar setting
1
6-10
11-15
16-20
21-24
NOTE: Because the above settings are only a
guide, use a piece of scrap material to test the dif-
ferent clutch positions before driving screws into
the workpiece.
Using Control Switch
The control switch may be set to three positions:
forward, reverse and lock. Due to a lockout mecha-
nism, the control switch can only be adjusted when
the ON/OFF switch is not pressed. Always allow
the motor to come to a complete stop before using
the control switch.
For forward (clockwise) rotation, push in the con-
trol switch from the right side of the tool. Check the
direction of rotation before use.
For reverse (counterclockwise) rotation, push in
the control switch from the left side of the tool.
Check direction of rotation before use.
To lock the trigger, push the control switch to the
center position. The trigger will not work while
the control switch is in the center locked position.
Always lock the trigger or remove the battery
pack before performing maintenance, changing
accessories, storing the tool and any time the tool
is not in use.
Fig. 4
Push for
Forward
PUSH TO CENTER TO LOCK
17
Cat. No. 2601-059
1,1 - 1,7 N·m
2,1 - 2,5 N·m
2,8 - 3,2 N·m
3,6 - 4,0 N·m
4,4 - 6,3 N·m
Cat. No. 2602-059
1-5
1,9 - 3,1 N·m
3,2 - 4,2 N·m
4,3 - 5,2 N·m
5,3 - 6,8 N·m
Torque
Torque
0 - 1,8 N·m
Push for
Reverse