Pks-1 Key Selector - Accessmatic Dogo 1224 Manual De Usuario

d
ogo
1224
5). Connect the four wires of the light and the antenna to the PCB terminals and place the wires into the conduit if
necessary. See Figure 3.3.3 (5).
6). Tighten the four screws back on the light base. Figure 3.3.3 (6)
7). Replacing the bulb set. See Figure 3.3.3 (7)
7.1) Unscrew the flashing light wires from the PCB terminals and make sure the power of the light is off.
7.2) Release the three screws (A)、(B)、(C) of the flashing light cover.
7.3) Separate the flashing light cover and replace the bulb set with a new one.
7.4) Tighten the three screws (A)、(B)、(C) of the flashing light cover.

3.3.4 PKS-1 Key Selector

1). PKS-1 key selector is installed outside and close to the gate at the height of about 100cm, so that it could be used by
most people. Decide the installa�on posi�on of PKS-1 first. See Figure 3.3.4 (1).
2). Remove the round cover (A) by prizing it out with a screwdriver. See Figure 3.3.4 (2).
3). Unscrew the two screws beside the lock body. See Figure 3.3.4 (3).
4). Turn the key and separate the bo�om of the shell with the lock body. See Figure 3.3.4 (4).
5). Breach the three holes at the bo�om and mark the points by the holes as reference.
6). Drill the holes in the wall and fix the bo�om to the wall by three screws. See Figure 3.3.4 (5).
7). Connect the electric wires to the terminals as shown in Figure 3.3.4(6), and it's not required to dis�nguish any polarity.
The terminals can be removed for connec�ng the wires easily.
8). Turn the key and insert the shell on the bo�om. Turn the key back to the center posi�on and the shell will be fixed to the
bo�om.
9). Tighten the lock body with the two screws and insert the round cover by pressing it to a�ach to the whole unit.
www.accessmatic.com
Opening your life
13