Bosch TS2100 Instrucciones De Funcionamiento página 8

Step 6
Attach Linkage Bars
1. Align hole in upper linkage bar with hole in
top tube bar as shown in figure G.
2. Place one (1) flat washer onto one (1) 10
mm x 100 mm bolt.
3. Insert bolt through linkage bar and place
another (1) flat washer on bolt between top
tube bar and upper cross bar.
4. Insert bolt through top tube bar, place one
(1) flat washer, and loosely tighten with
one (1) 10 mm lock nut.
Note: Do not over-tighten lock nut - these
parts need to freely rotate for stand to
operate properly.
Repeat this procedure on opposite side.
For Mounting Bosch 4000 / 4100 /
GTS1041A Table Saw to TS3100 Stand
1. To mount the 4100 / GTS1041A Table
Saw:
Align the saw as shown in figure A. Insert
one (1) 6 mm x 110 mm hex head bolt
through mounting hole in table saw and
through stand table top.
To mount the 4000 Table Saw:
Align the saw as shown in figure B. Insert
one (1) 6 mm x 75 mm hex head bolt (not
included) through mounting hole in table
saw and through stand table top.
2. Place one (1) 6 mm flat washer and
securely tighten with one (1) 6 mm lock
nut.
Repeat this procedure on the three
remaining mounting holes.
For Mounting Table Saw to Stand
FIG. G
Lock Nut Top Tube
Bar
Washer
-8-
Linkage Bolt
Bar
Washer Washer
FIG. A
TS3100