Initial Operation - SATA jet 1000 ROB RP Instrucciones De Servicio

to quick-change coupling.
■ Connect material supply to quick-
change coupling (option: connect
material connection inlet and material
connection return to quick-change
coupling with material return).
8.3. Use with material circu-
lation
Information!
If the automatic gun is used with
material circulation, the following
connection possibilities are rec-
ommended.
■ Install a return pressure regulator
at the material outlet.
■ Use a smaller line cross-section for
the material return.
This ensures that the paint nozzle
is always supplied with sufficient
material.
Material circulation keeps the ma-
terial used in motion, preventing it
from standing still.
The "nozzle head with material
circulation" version of the automatic
gun can only be used with material
circulation. This requires proper
connection of the material supply
(see Chap. 8.1 and 8.2).
The "nozzle head with optional
material circulation" version of the
automatic gun can also be used
with material circulation.
■ Disconnect automatic gun from
compressed air circuit and material
supply.
■ Screw dummy plug [5-1] out of nozzle
head.
Operating Instructions for SATA ROB Automatic Guns
■ Connect circulation line with gasket
To use the automatic gun again
without material circulation, it is
necessary to reinstall the dummy
plug and screw it in against the
stop. Secure with Loctite 242.
Pay attention to damage and
contamination and replace com-
ponents as required.
9.
Loose screws can lead to part
damage or malfunction.
→ Tighten all screws by hand and
check for tightness.

9.1. Initial operation

The automatic gun is delivered
completely assembled and ready
for operation.
After unpacking check to ensure:
■ That automatic gun is not damaged.
■ The scope of delivery is complete
to material connection for material
circulation [5-2].
Information!
Operation
Notice!
(see Chap. 5).
US
417