Cover Disassembly And Installation; Metal Cover Disassembly And Installation - toscano TDS600 Serie Manual De Usuario

Ocultar thumbs Ver también para TDS600 Serie:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

3.2.2. Cover disassembly and installation
3.2.2.1. Cover disassembly and installation
01.
Disassembly
Located the thumbs to the side bayonet, the ring fingers on the joint of the up
and down cover, with thumbs press inside and pull upside at the same time
until the bayonet open between cover and whole case, then pull back cover to
make it off the inverter.
02.
Assembly
1º Tilt cover at 5~10 degree;
2º Interface installation claw with hook on the top of inverter, press down
heavily till cover bayonet enter into the holes of two side completely, show as
Fig.3-4.
Fig.3-3 key board disassembly
3.2.2.2. Metal cover disassembly and installation:
01.
Disassembly
First take off 2 screws at the side of the cover and move it a bit outward
horizontally, then tilt it at 15 degree and draw it outward at the direction
shown in right figure, now you can take the cover off.
02.
Assembly
First put down the cover in parallel with unit body and make it just locked at
two sides of the inverter, secondly force it ahead and make fixing part on its
top inserted into fixing slot of unit body, at last screw the cover and finish
assembly for the cover. As shown in Fig.3-5
Fig.3-4 Cover disassembly and installation
3. Installation and wiring
133

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido