Troubleshooting - Kenmore 665.1452 Manual De Uso

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

PROBLEM
DISHWASHER DOES
NOT RUN
DETERGENT REMAINS IN
THE DISPENSER OR TABLET
IS ON BOTTOM OF TUB
CYCLE RUNS TOO LONG
DISHWASHER NOT DRYING
WILL NOT FILL

TROUBLESHOOTING

CHECK THESE POINTS TO HELP SAVE YOU TIME AND MONEY
SOLUTION
NOTE: It is normal for the dishwasher to repeatedly pause several times during a cycle.
Be sure the door is closed and latched.
Check that there is not an interference with large casserole dishes and the wash system
I
at the back of the dishwasher.
Check to see if any items are protruding through the bottom or back of the rack. Also
I
check to see if tall items are hitting the upper rack or spray arm. Adjust loading as
necessary to ensure door is closed and latched.
option. Controls must be awakened after a period of inactivity.
the controls.
Be sure you have selected a cycle. See the "Cycles and Options Information" section.
Be sure there is power to the dishwasher. A circuit breaker or fuse may have tripped.
Check for dishware such as cookie sheets, cutting boards, or large containers, etc., that may be
blocking the detergent dispenser from opening properly.
Be sure your detergent is fresh and lump free.
If the cycle has completed the Complete indicator light will be on in the display. If it has not
NOTES:
To use less water and reduce energy consumption you will encounter cycles that typically run
I
car slower saves on gas.
A water heater setting of 120°F (49°C) is best, the dishwasher will delay longer while heating
I
cooler water.
Some options will add time to the cycle. See the "Cycles and Options Information" section.
I
The
Turbo Heat Dry option adds approximately 45 minutes.
Try the 1 Hour Wash cycle. The 1 Hour Wash uses more energy and water to clean the dishes in
less time.
Run the hot water at a faucet close to the dishwasher before starting the cycle.
NOTE:
surface which tends to collect water droplets. Towel drying may be necessary.
Use of rinse aid along with the Turbo Heat Dry option is needed for proper drying.
Glasses and cups with concave bottoms hold water. This water may spill onto other items
when unloading.
I
Locate these items on the more slanted side of the rack for improved results.
I
Be sure the water is turned on to the dishwasher.
Features" section.
Check for suds in the dishwasher. If foam or suds are detected, the dishwasher may not operate
21
Tabla de contenido

Solución de problemas

loading

Tabla de contenido