Setting Of Switching Points For The Signal Output With [H-2] And [H-2] - schmalz SCPi Instrucciones De Servicio

Setting of switching points for the signal output with [H-2] and [h-2]

The activation value
parts control signal output are set using this function.
[H-2]
When the value is reached or exceeded, then the H2 LED is also switched on.
The switching points of the parts control signal output are set as follows:
 Press the
 Enter a valid PIN if the menu is locked.
 Select the desired
 Confirm by pressing the
 Change the value using the
 Press the
The display automatically jumps to the next setting value.

When the
changed is scrolled through quickly.

The value is not accepted when exited using the

Changes to the configuration of the
configuration menu.
S
C H MA LZ
[H-2]
(when configuring the
button.
[H-2] [h-2]
or
button.
or
button to save the changed value.
or button is pressed for approx. 3 seconds, the value to be
SCP / SMP
I I
[no]
output) and hysteresis
parameter using the
buttons.
[no] [nc]
or signal output are made in the
GB - 11
[h-2]
or buttons.
button.
of the