Tabla de contenido
CM-4050HD Installation Instructions:
The CM-4050HD antenna has two mounting options. It can
either be clamped to a surface using the included clamp,
or can be placed on a table top using the supplied stand.
Clamp Base Installation
1. Identify the direction of the desired TV station's
transmitter by using www.antennaweb.org.
2. Loosen up the wing nut on the back of the clamp
base to open up the clamp to the required width. The
clamp base can be used to mount to surfaces that are
1" to 2.5" thick. See Fig. 10a and 10b
3. Place the clamp base over the surface to which it
will be installed, and tighten up the wing nut until the
clamp base is firmly attached. See Fig. 11a
4. Install the antenna onto the clamp base by snapping
the post on the antenna into the hole in the clamp
base. See Fig. 11b
Table Top Stand Installation
1. Identify the direction of the desired TV station's
transmitter by using www.antennaweb.org.
2. Install the antenna onto the table top base by
snapping the post on the antenna into the hole in the
table top base. See Fig. 12
3. Place the Indoor Antenna on or near the TV set.
20
Tabla de contenido
