HumanTechnik TA-2 Instrucciones De Servicio página 9

Operation
Before using the telephone
amplifier please follow these
instruction.
1. Telephone receiver cord
First take the wallplug out of
the socket for your telephone
connection. Remove the re-
ceiver cord from its cable guide
on the underside of your tele-
phone. To do this, push the
locking clip towards the body of
the plug at the same time as
pulling the plug out of the
socket using the cord. Take this
plug on the end of the tele-
phone receiver cord and push it
into the socket on the back of
the telephone amplifier so the
plug clips into place. The socket
is identified with a telephone
receiver signal.
2. Connection cord
Take the plug on the end of the
connection cord for the hearing
amplifier and push it into the
receiver socket on the base of
the telephone. Position the
cord in the empty cable guide.
Finally reconnect the wallplug
into the wall socket for your
telephone connection.
Youe telephone is now ready to
operate again.
Switching on
The hearing amplifier automati-
cally switches itself on when
you pick up the handset of the
telephone. The green light on
top of the unit lights up to indi-
cate this.
Setting the volume / tone
You can use the tumbler dial on
top of the hearing amplifier to
adjust the volume of the signal
to a comfortable level. Turning
the dial towards the larger num-
bers on the scale increases the
volume, and vice versa. You will
be able to feel the stop at eit-
her end of the dial's travel.
Please do not try to force the
dial past these points. In additi-
on, you can adjust the tone
using the tone control.
Switching off
The hearing amplifier switches
itself off automatically about 60
seconds after you put the hand-
set back on the hook. The
green light goes out again.
Possible connections
The TA-2 is equipped with a
3.5 mm stereo jack socket to
which the following accesso-
ries can be connected:
english 9